Premium Rumble Bracket for Nintendo Gamecube Controllers

These custom 3D printed rumble brackets are a great upgrade to any gamecube controller, featuring:

• Slim & durable design
• Lightweight (0.4oz vs 1.4oz OEM)
• Hidden wire channel *inside* the bracket for routing the rumble wire
• Channels underneath for routing wires from other mods and connections (snapback, trigger paddles, ect)
• Customizable rumble strength (info below)

Package Contents:

• 1x Rumble Bracket w/ pre-installed coreless motor
• 3x M1.6 T4 screws (2 for mounting the bracket to the motherboard and 1 for the motor cover)
• 1x T4 Mini Screwdriver

To install this mod, you WILL NEED soldering skills (for attaching the positive and negative wires to the motherboard) 

To adjust rumble strength:

• Open the top compartment up by using the provided hex screwdriver. Using a small flathead (very small), turn the dial on the square white potentiometer to the right for increased strength and to the left for decreased strength.
• For those using these with Phob 2.0+, you can adjust the rumble strength via phob settings as normal.

Other notes:

• This bracket has been tested/used/compatible with: T1 OEM, T2 OEM, T3 OEM, & Phob 2.0+ motherboards. For other motherboard types, buy at your own risk.
• There may be small minor imperfections in the print (as with most 3d printed products). This will in no way effect the mechanical nature of the bracket.
• Be sure not to over-tighten the mounting screws as this could cause stripping of the PCB.